Getting Better WiFi

As I've written in the past, I replaced all my WiFi equipment with Ubiquiti's UniFi gear. For my relatively small 1600 square foot house, I've gone overboard and have 3 access points. The house is a tri-level house so ideally I'd put once access point on each level. Unfortunately, due to convenience, I didn't do that.

I set up one access point in my networking closet near my office on the ground floor, one in the garage in the hopes that it would cover up (yes, I know it points down) and one behind the TV on the mid level (wall mounting is not a great option). While WiFi coverage was adequate, I'm always looking at ways to improve my network. A few weeks ago, I decided to put the access points where they belonged. Since I have attic access above the mid level and second story, I just had to get a Cat6 cable up there. After several hours of trying to get 2 wires through a hole in the garage (I have about 6 other wires through that same hole and didn't want to make a new one) I managed to pull the cable and wire things up.

The result can be seen in these pictures; the access points pretty much blend in with motion detector and the smoke detector.

The coverage is now very consistent throughout the house and my wife hasn't complained about the access points on the ceiling!

IMG 6403

IMG 6407